Driver:HP300

From MAMEDEV Wiki
Revision as of 15:22, 30 May 2020 by Dukzcry (talk | contribs)

MAME HP 9000/370 Howto

Notes:

  • This manual applies to MAME 0.204 and later

Networking

See Driver:Apollo#Networking

Software Installation

How to setup the ROMs

├── dio98550
│   └── 98550a.bin
├── hp9122c
│   └── 09122-15515.bin
├── hp9k370
│   ├── 1818-4416.bin
│   ├── 1818-4417.bin
├── human_interface
│   └── 1820-4784.bin

http://www.bitsavers.org/bits/HP/HP_9000/firmware/dio98550.zip

http://www.bitsavers.org/bits/HP/HP_9000/firmware/hp9122c.zip

http://www.bitsavers.org/pdf/hp/9000_300/firmware/9000_370.zip

http://www.bitsavers.org/bits/HP/HP_9000/firmware/hp9k380.zip

Installation images

http://bitsavers.org/bits/HP/HP_9000/HPUX_9/CD/hpux9_install.iso

http://bitsavers.org/bits/HP/HP_9000/HPUX_9/CD/hpux_9.1_update.iso

GNU toolchain and utilities

How to create a new disk image file

  • to create a new 1900 MB disk image use chdman utility from MAME package
$ chdman createhd -f -o hpuxtest.chd -s $[1900*1048576]

Installation guide

$ mame64 hp9k370 -sl2 98643 -hard hpuxtest.chd -rp . -window -mouse -uimodekey DEL -cdrom hpux9_install.iso

This will boot the installer:

Press <Enter> to continue:

Installer searching for disks:

It found our disk image:

Say 'y' to have long file names:

Press '1' to continue:

Accept the default swap setting by pressing enter:

And, once again, press 'y' to continue

Installer starts creating the filesystem:

Installer extracting the minimum HP-UX system:

The installer is now asking for the update CDROM:

Enter the Menu (DEL to activate UI, then Tab to enter menu), and select 'hpux_9.1.update.iso':

Press Tab to close menu and DEL to deactivate UI mode

After that is done, the installer shows the main menu, press enter to select all filesets:

Press Enter once again to confirm that you to install these filesets:

And, 'y' to really install:

And this is the final install screen. After it finishes install, it will reboot into HP-UX from hard disk.

Running VUE

Login as root and type

$ init 3

After some time, it will start VUE session